FM809 – LMS Signal Box, Spondon
- Ready to Order
| Length* | Width | Height | *With Steps | |
| OO | 218 | 57 | 95 | 266 |
| HO | 191 | 50 | 83 | 232 |
| 3mm | 166 | 43 | 72 | 202 |
| TT120 | 138 | 36 | 60 | 168 |
| N | 112 | 29 | 49 | 137 |
| Length* | Width | Height | *With Steps | |
| OO | 94 | 57 | 95 | 137 |
| HO | 82 | 50 | 83 | 120 |
| 3mm | 71 | 43 | 72 | 104 |
| TT120 | 60 | 36 | 60 | 87 |
| N | 48 | 29 | 49 | 70 |
⚠ Copyright & Design Protection
Every model sold by Inoxion Models has been designed or licensed for sale by us. Product photographs, 3D renders, digital files, model designs, and written content remain the intellectual property of Inoxion Models.
Copying, scanning, moulding, recasting, 3D reproducing, sharing, distributing, or selling our products or digital content without written permission is strictly prohibited. We routinely monitor online marketplaces and websites for copyright infringement and will take appropriate legal action where necessary.
Do the Models Come Painted and Assembled?
All our products are supplied unpainted.
Most figures are printed as a single piece and do not require assembly. However, some larger or more detailed models—such as wagons and cannons—may be supplied in separate parts and require minor assembly.
Preparing Resin Models for Painting
These recommendations apply only to resin parts purchased from us. We cannot guarantee that they will be suitable for products supplied by other manufacturers.
- Gently wash all parts using lukewarm water and washing-up liquid. Do not leave them soaking.
- Avoid using hand soap, as some contain lotions or moisturisers that may interfere with primer and paint adhesion.
- Allow the parts to air-dry completely, away from direct sunlight.
- Carefully sand away any visible print lines or support marks, as required.
- Fill any small pinholes or surface imperfections with a suitable modelling filler.
- Wash the parts again to remove any sanding dust, then allow them to dry completely.
- Apply a suitable primer before painting.
- Paint using your preferred modelling paints.
Warped Parts
If a part arrives slightly warped, carefully warm it in hot—but not boiling—water until it becomes flexible. Gently reshape it, then place it in cold water to help it retain its corrected shape.
Do not attempt to force a warped resin part back into shape while it is cold, as this may cause it to snap.
Tacky Parts
Very occasionally, a resin part may feel slightly tacky. Wash it as described above and allow it to dry completely. Once dry, place it in direct sunlight for approximately 5–7 minutes. Do not leave it outside for an extended period, as excessive heat or sunlight may cause warping.
Feel free to reach out to us if you have any questions.
Usually Dispatched within 7 Working Days by RM48
1. Does the product come with supports still attached: Yes
